Power up the primary Rx by plugging in the S.Bus connector.Ħ. Use the rotary around the RTN button to select the left-hand LINK field and tap RTN. On the Tx press the LNK button twice quickly, then use the rotary around the RTN button to select SYSTEM and tap RTN.Ĥ. The receiver between booms 1 and 2 will be the primary receiver as it has the voltage sensor connection.ģ. With the ALTA powered on, disconnect the S.Bus connector from both receivers.Ģ. Both Rx should show a solid green.įor my ALTA, one of the two Rx I received was linked (solid green), the other was not (solid red), but even though you can see the ID numbers on the SYSTEM screen on the transmitter (Tx) as far as I could tell you cannot tell which of the Rx needs to be re-linked, so you have to do both.ġ. Here's a step by step procedure if either receiver shows a solid red LED (meaning it is not linked).
0 Comments
Leave a Reply. |